Introduction
This section contains information about how to build BM prototipes by yourself. For now, “Zora” is the only available but we plan to add more as the project go on.
Zora
Zora is the codename for the second BondMachine prototipe, the first with a monitor and a keyboard. It is based on a Basys3 evaluation board. To build it you also need a 3D printer and a tool to cut and engraving the plexi.
The result of the process will be something like this:
Shopping list
| Digilent Basys3 |  |
| 7 inch VGA HDMI monitor (like the 7300101463 E231732) |  |
| An USB (power) to jack female (5.5mm - 2.1mm) |  |
| A couple (male female) of jack connector (5.5mm - 2.1mm) |  |
| An usb type A female to micro USB male (10 cm) |  |
| An usb type A female to male (10 cm) |  |
| Some spare wire |  |
| A short VGA cable (3cm) or eventually 2 male VGA connectors to solder it |  |
| A 2 pin dupont female connector |  |
| Some 3D printer silk |  |
| Some plexiglass (3mm) and a tool to cut and engraving it |  |
Howto
Connections
3D printed case
The 3D case of zora can be downloaded as sigle tgz file with all parts.
|
All 3D models |
Or each model separately.
 |
Cover Frame |
 |
Cover Support dx |
 |
Cover Support sx |
 |
Front Grid |
 |
Main Case |
 |
Plexi Cover |
 |
Screen Back |
 |
Screen Cover |
 |
Screen Support dx |
 |
Screen Support sx |
Thanks
Many thanks to:
- Cristiano Turrioni (3D Design)
- Giacomo Surace (Printing)
- Igor Neri (Engraving)